GMC Sierra 1500 1999, Door Lock Actuator Motor by ACI®. This premium product is the best way to go for those looking for the highest quality replacement that.
Onsite Associates Program. Product description Strattec/OEM #707835 + 706592 X2 + 598007 X2 CHEVROLET Factory Original Ignition Switch Lock Cylinder + 2 (Pair) Door Locks Cylinders + 2 OEM Chevy Logo Key To Match ATTENTION: THIS SET FOR MODELS WITH AUTOMATIC TRANSMISSION ONLY. Tahoe, GMC Sierra, Yukon, Yukon XL GM1310129 (1999, 2001, 2002.
1999 GMC Sierra power door locks. Apr 09 2016, 1:06am. I have a 99 Sierra. The power door locks works great on the drivers door, on the passenger door the power locks.
GMC Sierra 1500 1999, Door Lock Kit by Standard®. Finish: Chrome. SMP’s vision is to be the leading independent supplier to the automotive aftermarket, providing the highest quality products, competitive prices and the highest.
2. Insert key into ignition
3. Hold down the power UNLOCK button on the driver’s door panel, continue to hold down until instructed to release in step 9.
5. Turn the ignition to the ON position (as far as you can go without starting the engine.)
6. Turn the ignition to the OFF position.
7. Turn the ignition to the ON position (as far as you can go without starting the engine.)
8. Turn the ignition to the OFF position.
9. Release the power UNLOCK button on the door panel. The vehicle should respond by door locks locking and unlocking automatically. (If locks do not cycle after you let go, not before you let go of the unlock button, then the vehicle has not entered programming mode and you must start procedure over. Remove key from ignition, open drivers door and return to step 1 ). If the locks do cycle automatically then proceed to step 10.
10. Hold down the LOCK and UNLOCK buttons on the remote until the doors lock and unlock. This may take up to 30 seconds.
11. Repeat step 10 NOW for each additional remote. (Including any existing remotes).
12. Turn the ignition to the ON position to exit the programming mode.
1. Locate the Data Link Port. It is located under dash drivers side. Be sure you know which pins are 8 and 4.
(Notice port is wider on top row)
2. Make sure there are metal contact pins in terminals 8 and 4. Connect 8 to 4 with a suitable jumper wire (leave the jumper wire connected throughout the programming procedure). Make sure you know which terminals are 8 and 4. The vehicle will respond by locking and unlocking the doors to signify entering of programming mode.
3. Press and hold both the LOCK and UNLOCK buttons together on the first transmitter to be programmed. After about 15 seconds, the vehicle will respond by locking and unlocking the doors. Release the buttons on the transmitter.
4. Within one minute, repeat the previous step on the remaining transmitters to be programmed.